Digital Vinyl Banner Printing : How to Print a Banner

Digital Vinyl Banner Printing : How to Print a Banner


Hi everyone, I’m Doug Downey on behalf of
Expert Village, I’m here today to show you how to digitally print vinyl banners. Now
we have our banner all printed and ready to, to deliver to the customer. So one of the
things we have to do, is trim the banner between the two grommets where we started the print
off. So what I’ve done here is, I’ve just drawn a quick line between the two grommets,
measured it out so that we’re, we’re equal on both sides, and I can just take a pair
of scissors and just trim it off. Do a nice quick cut up and cut through the welded, welded
edge. And again, like I said earlier if we have a, if we have a full bleed print, you
can actually take this here and you can trim that off and again, you can just trim along that line,
it will show you that you can leave the grommet in. You still have at least a good three-quarters
of an inch of grommet, of welded material that has the grommet in, that’s nice and
strong, and they are very low, thin profile grommet, that you can use, that you can screw
up anywhere. One of the nice things compared to the older grommets is that the hole is
a little bit smaller too, takes small screw-heads now. So you won’t have to get some great
big washers to secure it to a fence or a building or something like that.

4 Replies to “Digital Vinyl Banner Printing : How to Print a Banner”

Leave a Reply

Your email address will not be published. Required fields are marked *